Manual is in German but complete. I needed this one to fix a long lasting problem with the internal PSU of the camera. Most of the capacitors begin to leak after a few years wich results in the inability to power on the camera. When you try to turn it on the power led flickers and the unit directly turns off. Thanks to this manual I was able to locate all bad cap's and to dis- and reassemble the camera without any problems.
Excellant, finally this is want I need and searching for The service manual is fantastic and thank you to owner-manuals.com and its service. Price is reasonable. It's a bit slow on my end in downloading but manage to receive the whole manual without a break. once again, thanks.
Very good scanning quality. All schematics are very legible. Worth every cent !
Text excerpt from page 402 (click to view)
Rewriting the ECC Board Data (option)
1. Unplug the power cord from the power outlet with the Power Switch OFF. 2. Remove the Rear Cover. 3. Insert the memory card into the ECC Board.
4. Plug the power cord into the power outlet. 5. Turn ON the Power Switch. 6. This starts the rewriting sequence. NOTE D1 on the Master Board remains blinking while data is being rewritten.
7. Check that D3 on the ECC Board turns ON. 8. If an LED other than D3 turns ON or if it takes longer than 3 min. to rewrite the data, perform steps 9 and 10, turn OFF the Power Switch, and start the procedure over beginning with step 4. 9. Unplug the power cord from the power outlet. NOTE At this time, do not turn OFF the Power Switch. 10. Remove the memory card.