|
Who's Online
There currently are 5953 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
The ease of this purchase was a good start. The content of this manual was exactly all I needed to retore my Tandberg 64.
All of the mechanical and electrical information is contained in the manual and the quality of the document makes reading the data easy.
The exerience with the resource has made this my prime source for technical data.
;
Owner-manuals.com is the best Possibility to give vantage HIGH CLASS Elektronic COMPONENTS
a new Life.Thanks alot for your perfekt Service.
;
I am proud of you. In the future, I benefited from your services.
;
I found this manual to be complete in every detail. Besides the schematic it has a complete set of alignment instructions which are easy to understand. It also includes a complete parts list as well as an explanation of how the power supply and safety shutdown circuits operate. Even a schematic of the tuner is included.
;
The product was good and just what I needed, however I had moderate difficulty with the down load because the sight would not recognize my pass word. I was finally given a direct link to the manual and that worked.
FrameMaker Ver5.5E(PC) Di152/Di183 SWITCHES ON PWBs/TECH. REP. SETTINGS 01.07.26
Code No.
Setting (The default is Highlighted ). <Delete Account> Delete an account (access number) which has previously been stored. <Procedure> 1. Enter �3� from the 10-Key Pad. (Display: A-3) 2. Press the Start key. This will blank out the Display. � If no accounts are yet to be programmed, the contents of the Display alternate between �A-3� and �blank.� 3. Press the Zoom key to display the account to be deleted. 4. Press the Start key to delete the account. <Change Account> Change an access number which has previously been programmed. <Procedure> 1. Enter �4� from the 10-Key Pad. (Display: A-4) 2. Press the Start key. This will blank out the Display. � If no accounts are yet to be programmed, the contents of the Display alternate between �A-4� and �blank.� 3. Press the Zoom key to display the access number to be changed. 4. Press the Start key to validate the access number displayed. 5. Enter a new access number from the 10-Key Pad. 6. Press the Start key to validate the new access number just entered. � If the new access number just entered already exists, �Err� appears on the Display and then the Display blanks out. In this case, perform steps 5 and 6 again. <Total Counter Display by Account> Display the count of the Total Counter for each account. <Procedure> 1. Enter �5� from the 10-Key Pad. (Display: A-5) 2. Press the Start key. This will blank out the Display. � If no accounts are yet to be programmed, the contents of the Display alternate between �A-5� and �blank.� 3. Press the Zoom key to display the access number. 4. Press the Start key to validate the access number displayed. 5. Press the Start key. This will allow the Total Counter value to be displayed. E.g.: �123� and �456� alternate if the count is 123,456. 6. Press the Clear key to clear the count. If the count is mistakenly cleared, press the Interrupt key, which will restore the count just cleared. <Total Counter Clear for All Accounts> Clear the Total Counter counts for all accounts. <Procedure> 1. Enter �6� from the 10-Key Pad. (Display: A-6) 2. Press the Start key. Then, �CLr� appears on the Display. 3. Press the Start key again to clear all counts.
A-3
A-4
A-5
A-6
S-12
|
|
|
> |
|