I found the manual to be clear concise and complete. It was of immense assistance when removing the unit as the unit was over 22 years old and the wiring diagram was unobtainable from the manufacturer. The exploded drawings were clear as were the instructions and labels.
Very pleased with the quality of the scan. No complaints whatsoever.
Text excerpt from page 279 (click to view)
3. Press the Start key to feed paper through the copier to determine if an adequate length of loop is formed before the Fusing Rollers.
1154D215AA
1154D212AA
1154D213AA
Retarded
Correct
Advanced
The loop length is too long causing the paper to have too much slack.
A good length of loop is No loop is formed causing the formed as the paper moves paper to be taut. into the Fusing Rollers. 4. If the timing is advanced or retarded, change the setting of Fuser Speed. Adjustments Retarded: Increase the setting. Advanced: Decrease the setting. 5. Check the length of loop again and repeat the above steps until a good length of loop is obtained. 6. Using the same procedure, adjust for �Heavy Stock 2 and OHP Film�. 7. After the adjustments have been made, touch �Ex.�.